TissyD Full Member Messages 365 Jan 2, 2020 #1 Our Carver water heater heats up okay but sometimes it then trips the overload. Any ideas please?
St3v3 Full Member Messages 1,716 Jan 2, 2020 #2 You mean on the unit itself? I think it has a thermostat that would normally turn it off, and the cut out as a safety if it doesn't. So your thermostat could be dead. Is this a Malaga? I may have a spare bit at home...
You mean on the unit itself? I think it has a thermostat that would normally turn it off, and the cut out as a safety if it doesn't. So your thermostat could be dead. Is this a Malaga? I may have a spare bit at home...
TissyD Full Member Messages 365 Jan 2, 2020 #3 Yes it is the overload on the unit. I will have to have a look tomorrow to see which model it is. Thanks
Yes it is the overload on the unit. I will have to have a look tomorrow to see which model it is. Thanks
yorkslass Full Member Messages 4,085 Jan 2, 2020 #4 Not positive, but given that its a similar age to ours it may be the same.....carver cascade