Help

[The laird]

Trying to locate a wheel centre for the hymer alloy
Here's a snap it's the greyish plastic centre it's the whole thing circled in green

 

[Pudsey Bear]

I can't tell from that picture, but does this help

Pardon our interruption...

 

[Pauljenny]

Looks like you've been to Liverpool...?
Can't Hymer help..?

 

[The laird]

Looks like you've been to Liverpool...?
Can't Hymer help..?

Awaiting h6mer getting back but been told they're expensive
Surprise surprise

 

[Molly 3]

CAnt beat plastic wheel trims £ 5 each

 

[alwaysared]

Awaiting h6mer getting back but been told they're expensive
Surprise surprise

How about a 3D printer? You could use one of the others for a pattern

Regards,
Del

 

[The laird]

How about a 3D printer? You could use one of the others for a pattern

Regards,
Del

Yeah looking like that's going to be the way to go del
According to some things I've found out they cost as much as a alloy from hymer?

 

[Pudsey Bear]

I might just get a full set of Merc/Fiat trims Gordon, I have had a good search and can't find any that look like the op pic, could do with a better one really.

 

[The laird]

It's this grey 5 leaf shaped flange/wheel centre inside coloured circle
Will remove one tomorrow if I can and photo it

 

[alwaysared]

Yeah looking like that's going to be the way to go del
According to some things I've found out they cost as much as a alloy from hymer?

I'd suggest asking Steve (St3v3) but I was talking to him at Hereford and asked about some covers for my bike rack mounts but he said that you need a different type of "plastic" than one Tommy uses for outdoor use

Regards,
Del

 

[The laird]

Yeah think it will need to be a commercial printer going to try a company up here next week Derek

 

[runnach]

Bump, how did you get in with this Gordon + result?